Hornplate alignment tool
3 posters
Page 1 of 1
Hornplate alignment tool
Having got Kit 10 Crankshaft bearing housings in place I tried the alignment tool but after removing any corner burrs it does not fit in either housing. Its a very small amount - Should I just file edges until it slides into housings individually before getting to alignment process to make sure it slides in both ? I am assuming housings right size.
Any advice out there
RMc
Any advice out there
RMc
RMc- Number of posts : 24
Location : Tarbert Argyll
Registration date : 2014-11-26
Re: Hornplate alignment tool
Hi,
I had the ssme issue last week as it was only a few thou, I contacted Steve, he advised to file carefully off both ends until they fit snug. To be sure only file from the same face on each end. I filed the faces facing the cylinder. The tool fits perfect. The alignment is spot on.
Mike
I had the ssme issue last week as it was only a few thou, I contacted Steve, he advised to file carefully off both ends until they fit snug. To be sure only file from the same face on each end. I filed the faces facing the cylinder. The tool fits perfect. The alignment is spot on.
Mike
Hornplate alingment tool
Many thanks Mike - will do
Robert
Robert
RMc- Number of posts : 24
Location : Tarbert Argyll
Registration date : 2014-11-26
Re: Hornplate alignment Tool
Hi, the alignment tool, which kit does it come with? I've had up to kit 11b, so far
Charlie
Charlie
chas12154- Number of posts : 412
Age : 63
Location : Totton, Southampton, Hampshire
Registration date : 2015-01-21
Re: Hornplate alignment Tool
Thanks Mike, got a couple of kits to go yet then.
Charlie
Charlie
chas12154- Number of posts : 412
Age : 63
Location : Totton, Southampton, Hampshire
Registration date : 2015-01-21
Similar topics
» Looking for a Hornplate Alignment Tool
» Hornplates alignment tool
» Hornplate alignment.
» Diary for RL "Giuseppina"
» Misalignment Of Cylinder Block Holes
» Hornplates alignment tool
» Hornplate alignment.
» Diary for RL "Giuseppina"
» Misalignment Of Cylinder Block Holes
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|