2" Cylinder cleading
2 posters
Page 1 of 1
2" Cylinder cleading
When trying to fit the cylinder cleading the screws start in the thread and that's about all. Are the 8BA screws the right thread? Has anyone else had this problem?
geoffmills1946- Number of posts : 6
Location : Gloucester
Registration date : 2008-07-07
Re: 2" Cylinder cleading
Hi Geoff
I had a similar problem to start with,but I solved it by clearing the threads with an 8BA tap.
Be careful though because I found that a couple of the holes were shorter than the screws.
Hope this helps,
Tony
I had a similar problem to start with,but I solved it by clearing the threads with an 8BA tap.
Be careful though because I found that a couple of the holes were shorter than the screws.
Hope this helps,
Tony
TonyT- Number of posts : 134
Age : 56
Location : Truro,Cornwall. (2" Burrell)
Registration date : 2008-06-17
Similar topics
» Cylinder block and cleading & Steering
» Boiler cleading
» 4" Burrell Kit 11A - Cylinder Block
» Kit 11 - Cylinder Block & Cylinder fittings.
» Lynn Robinson. Showman Scenic
» Boiler cleading
» 4" Burrell Kit 11A - Cylinder Block
» Kit 11 - Cylinder Block & Cylinder fittings.
» Lynn Robinson. Showman Scenic
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|