Rear Wheel Boss Hole Size
2 posters
Page 1 of 1
Rear Wheel Boss Hole Size
I have just received Kits 4 & 5 for building the rear wheels and find the sintered bronze bearings cannot fit the boss's bored hole.
Rough sizes are:
Shaft diam: 3/4"
Bronze bearing outer diam: 15/16"
Bronze bearing inner diam: 3/4"
Boss bored centre hole diam: 13/16".
In other words it looks like the boss has not been bored out enough to the 15/16" of the bearing.
Am I missing something or should I get on to STW.
Unfortunately I live in Florida, where it is sunny and gorgeous right now.
Peter
Rough sizes are:
Shaft diam: 3/4"
Bronze bearing outer diam: 15/16"
Bronze bearing inner diam: 3/4"
Boss bored centre hole diam: 13/16".
In other words it looks like the boss has not been bored out enough to the 15/16" of the bearing.
Am I missing something or should I get on to STW.
Unfortunately I live in Florida, where it is sunny and gorgeous right now.
Peter
mariserve- Number of posts : 10
Location : Florida USA
Registration date : 2016-05-11
Re: Rear Wheel Boss Hole Size
Think somebody else had this problem,recently.
I will see if i can find who
Steve H
I will see if i can find who
Steve H
Steve H- Number of posts : 189
Location : Wellingborough,Northants
Registration date : 2014-03-07
Similar topics
» Rear Wheel Boss Hole Size
» Fire Hole Size?
» Tip for assembling spokes for front wheel and rear wheel
» Getting Ready For GDSF
» Kit 8 - Steering Wheel Shaft Missing Fixing Hole
» Fire Hole Size?
» Tip for assembling spokes for front wheel and rear wheel
» Getting Ready For GDSF
» Kit 8 - Steering Wheel Shaft Missing Fixing Hole
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|