Kit 8 - Steering Wheel Shaft Missing Fixing Hole
2 posters
Page 1 of 1
Kit 8 - Steering Wheel Shaft Missing Fixing Hole
Not sure if it is just ours but for information the M4 tapped hole was missing in the Steering wheel shaft for the penny washer fixing. We have sorted it by sticking it in the Myford to drill the hole then tapped it M4.
Cheers
Nick
Cheers
Nick
FodenSWB- Number of posts : 27
Location : Tewkesbury
Registration date : 2012-08-31
Re: Kit 8 - Steering Wheel Shaft Missing Fixing Hole
We had the same problem but decided on going with an m6 hole for a bit more security. Did you by any chance have any problems with thepart of the brake that clamps around the axle not clamping tight?
Hecter- Number of posts : 50
Age : 30
Location : Luton
Registration date : 2013-02-13
Re: Kit 8 - Steering Wheel Shaft Missing Fixing Hole
We had a little clearance on the brake to axle casting but not excessive so we just used a small amount of bearing retainer when assembling and that did the trick.
Cheers
Nick
Cheers
Nick
FodenSWB- Number of posts : 27
Location : Tewkesbury
Registration date : 2012-08-31
Similar topics
» Rear Wheel Boss Hole Size
» Rear Wheel Boss Hole Size
» Hornplates/spectacle plates and rear wheel axle shaft
» Showmans/road loco Kit 18
» Thetford Works (Cornwall)
» Rear Wheel Boss Hole Size
» Hornplates/spectacle plates and rear wheel axle shaft
» Showmans/road loco Kit 18
» Thetford Works (Cornwall)
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|