Motion drip tray.

Hi STW.

A few moons ago I inquired about the piston drip tray. The screws did not fit. Your response was the holes were tapped to large in the second batch casting. Is there any sign of the modifications as things are getting busy around where the tray should be and soon will be almost impossible to fit.

ooh yes, thanks for reminding us on this one. you were supposed to get some larger fasteners and open out the holes in the tray.

i guess this never happened then ???

sorry bout that, i'll get on to it Monday

OK, just spoke to steve on this and it was decided to supply all the "M4" blocks with deeper drip trays.

the easy solution is to drill out the original holes to fit an M4 but with the trays being so shallow there is not much to play with.

the new ones are still to be made

Hi Craig

Ok Doky.

As you can see from my photo thread things are progressing well. Waiting for the next kit now.

Hi STW

Any ETD? on the revised drip trays.

in all honesty... no

not sure if Steve has had any thoughts on them but nothing has come down to the workshop yet.


thanks for the reminder

craig@STW wrote:in all honesty... no

not sure if Steve has had any thoughts on them but nothing has come down to the workshop yet.


thanks for the reminder

Gently prod again please.