burrell 2" painting query
2 posters
Page 1 of 1
burrell 2" painting query
I have just started a Burrell 2" Traction Engine kit. Has anyone hand painted one? If so,what paints did you use? If not, hat other methods of painting were used? I would appreciate expert opinions.
Patman- Number of posts : 3
Location : France
Registration date : 2010-06-12
PAINTING
I brush painted my 4" Burrell using Craftmaster paints. 1 coat primer (on steel parts),followed by 2 coats undercoat and 2 coats topcoat. Undercoats rubbed down with 600 or 800 paper used wet, and topcoats with 1000 or 1200 paper also wet. Followed by Farecla G3 Rubbing Compound and G10 Finishing Compound. This leaves a dullish shine which I, personally, find most acceptable. On brass of course use an etch primer first.
The paint finish even merited favourable comments in the modelling press !! See 'Engineering in Miniature' January 2010 p.225.
Best of luck,
DavidH
The paint finish even merited favourable comments in the modelling press !! See 'Engineering in Miniature' January 2010 p.225.
Best of luck,
DavidH
DavidH- Number of posts : 33
Location : Warwick
Registration date : 2008-11-14
PAINTING
I should have added that I used the best quality sable brushes. Expensive but worth it!
David
David
DavidH- Number of posts : 33
Location : Warwick
Registration date : 2008-11-14
Similar topics
» painting 2" Burrell
» 2" Burrell Kit 21
» Query on pipe fitting..
» Steam pipe from the Injector to the righthand Globe Valve
» Help - Cylinder Block Front Covers / Rear Piston cover sealant query
» 2" Burrell Kit 21
» Query on pipe fitting..
» Steam pipe from the Injector to the righthand Globe Valve
» Help - Cylinder Block Front Covers / Rear Piston cover sealant query
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|