4" Ruston Proctor - Boiler and lots of parts. Open to sensible offers. SOLD
Page 1 of 1
4" Ruston Proctor - Boiler and lots of parts. Open to sensible offers. SOLD
Load of parts for a 4″ ModelWorks Ruston Proctor. Everything has been just sitting around in a garage untouched for at least 13+ years. Most parts are covered in some sort of surface rust but they might be good for someone who was thinking of scratch building and has the capability to sort or clean everything up. No easy task though but a great start!
Lots there including the boiler (which looks okay), cylinder, trunk guide, horn plates, smokebox, tender, rear wheels, steering shaft and hand wheel, with some gears fitted and a number of bits bagged as per the photos.
Sold as seen with no paperwork or warranty. You get what you see. Will make a good little project for someone.
Check out the photos on the new 'second hand steam' section of our website using the link below.
http://www.steamtractionworld.com/kits/4-scale-ruston-proctor-bits/
Any enquiries to info@steamtractionworld.co.uk or call 01327 301030
Lots there including the boiler (which looks okay), cylinder, trunk guide, horn plates, smokebox, tender, rear wheels, steering shaft and hand wheel, with some gears fitted and a number of bits bagged as per the photos.
Sold as seen with no paperwork or warranty. You get what you see. Will make a good little project for someone.
Check out the photos on the new 'second hand steam' section of our website using the link below.
http://www.steamtractionworld.com/kits/4-scale-ruston-proctor-bits/
Any enquiries to info@steamtractionworld.co.uk or call 01327 301030
![-](https://2img.net/i/empty.gif)
» IanL Road Loco
» FAO, Steve. 4" Ruston Hornsby tracked engine.
» im from australia and need to know if the boiler needed to be change to suit aussie boiler code
» Crank Bearings.. your thoughts please
» Another New Showmans
» FAO, Steve. 4" Ruston Hornsby tracked engine.
» im from australia and need to know if the boiler needed to be change to suit aussie boiler code
» Crank Bearings.. your thoughts please
» Another New Showmans
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum