Cylinder oil passage ways
2 posters
Page 1 of 1
Cylinder oil passage ways
Hi all.
Has anyone else had problems with the lubricator oil inlet to the cylinder. It appears that the inlet where my lubricator feeds into is blind. After speaking to STW world they have said it my just be blocked with machining debris. But after removing the small stud from the cylinder rear it is not clear into the vertical opening that the lubricator pumps into. Hope that all makes sense.
Has anyone else had problems with the lubricator oil inlet to the cylinder. It appears that the inlet where my lubricator feeds into is blind. After speaking to STW world they have said it my just be blocked with machining debris. But after removing the small stud from the cylinder rear it is not clear into the vertical opening that the lubricator pumps into. Hope that all makes sense.
Pitpup- Number of posts : 108
Age : 55
Location : Cleveland
Registration date : 2015-02-28
Re: Cylinder oil passage ways
All sorted....it was simply the hole hadn't been fully drilled. After some advice of STW today I sorted it myself....#result.
Pitpup- Number of posts : 108
Age : 55
Location : Cleveland
Registration date : 2015-02-28
Re: Cylinder oil passage ways
Hi Pitpup,
Sorry to revive an old thread. Having just run mine on air for the first time this weekend I've discovered the same problem with mine. I think my cylinder may be one of the same batch as yours. Can you remember what you had to do?
Thanks
ian
Sorry to revive an old thread. Having just run mine on air for the first time this weekend I've discovered the same problem with mine. I think my cylinder may be one of the same batch as yours. Can you remember what you had to do?
Thanks
ian
IanR- Number of posts : 114
Location : Rochester Kent
Registration date : 2012-10-16
Similar topics
» cylinder kit
» Flywheel key ways?
» Kit 11 - Cylinder Block & Cylinder fittings.
» December Production photos...
» Advice on a 4" and help
» Flywheel key ways?
» Kit 11 - Cylinder Block & Cylinder fittings.
» December Production photos...
» Advice on a 4" and help
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|