Having trouble with weighshaft

Morning all, hope you are all well?
I am having trouble with my weighshaft. I can't seem to get one of the tapered pins out to get it though the weighshaft bracket. I haven't a small enough punch. Has anyone any idea where I can get one or how to get one of the pins out!

Charlie

Hi , i had the same trouble. I bought a thin center punch and after 2 hits one of the pins fell out. I hope this helps

Hi, where did you get punch from and what size was it? Been looking online at punches, but unsure which size I need

What about these?
http://www.toolstation.com/shop/Hand+Tools/d10/Punches/sd3302/Pin+Punch+Set/p44554

Steve H

The smallest one would be the right size?
I have seen sets but unsure what size I would need

I have bought a couple of these over the years and there cheap and i just bin them when there knackered.
Steve H

I have had a set, but broke the smallest one and never replaced it. Now I need it, I'm stuck till I get a new one!
Just ordered a set, should be here by Friday