Washout plugs
+2
lynnr
MrStationHouse
6 posters
Page 1 of 1
Washout plugs
I am putting my plugs in and they are a very tight fit , did anyone else struggle to get them in?
MrStationHouse- Number of posts : 314
Location : Malmesbury
Registration date : 2011-04-26
Re: Washout plugs
You may want to put a thread chaser through the holes as they could be a bit distorted or just roughed.
One of mine was slightly oval but a tap cured it.
One of mine was slightly oval but a tap cured it.
lynnr- Number of posts : 3242
Age : 55
Location : Highland, 4inch showman
Registration date : 2010-08-06
Re: Washout plugs
STW will lend you a tap. I had to clear my threads.
Tim
Tim
Tim Watson- Number of posts : 585
Location : Herts
Registration date : 2008-07-02
Re: Washout plugs
I had to run a tap through them, they were really tight. 3/4 BSP if I remember rightly.
Re: Washout plugs
i think there 3/8 bsp.
the coleman- Number of posts : 216
Age : 54
Location : worthing
Registration date : 2011-06-07
Re: Washout plugs
Thanks folk, glad I asked
MrStationHouse- Number of posts : 314
Location : Malmesbury
Registration date : 2011-04-26
Re: Washout plugs
The steam water lift connection is 3/4 BSP I also have the washout plugs to fit and they are smaller than that.
IanL- Number of posts : 437
Age : 68
Location : Nottinghamshire
Registration date : 2011-07-25
Similar topics
» Boiler washout plugs.
» Filler plugs
» New Boiler Washout?
» Tube plate washout plug
» New type of boiler level sensor
» Filler plugs
» New Boiler Washout?
» Tube plate washout plug
» New type of boiler level sensor
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|