Burner mounting
Page 1 of 1
Burner mounting
Having read of Skippy's mishaps, he and perhaps others of you might be interested to know of my solution. In the main casting of the burner body is a square hole running for and aft right through the casting, bottom right if viewed from the back. I assumed this was for 'taking the weight' as the boiler fitter slid the burner into position along a half-inch square rod fitted to the boiler ? Anyway, I decided to fit such a rod to my Lika to help deal with the loadings the bumps and pot-holes of our wonderful road network would impart.
The right-hand pair of the flange bolts can be used to also hold the bracketry to which you have bolted/welded the aforementioned rod. The final belt to go with the braces is to drill the rod for a split-pin at its outer end, fitting the pin after the burner is in place, hopefully keeping the burner there even if/when the pinch bolts vibrate loose.
Dave Granger
The right-hand pair of the flange bolts can be used to also hold the bracketry to which you have bolted/welded the aforementioned rod. The final belt to go with the braces is to drill the rod for a split-pin at its outer end, fitting the pin after the burner is in place, hopefully keeping the burner there even if/when the pinch bolts vibrate loose.
Dave Granger
dave granger- Number of posts : 9
Age : 80
Location : crick, northampton, England
Registration date : 2008-06-20
Similar topics
» 12 volt dc oil burner
» oil burner service
» burner fit
» Likamobile - Burner breakaway
» Riello Burner Delay
» oil burner service
» burner fit
» Likamobile - Burner breakaway
» Riello Burner Delay
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|