Thread sizes
4 posters
Page 1 of 1
Thread sizes
It's a pity there is no database listing all the thread sizes for the DCC.
Can anyone recommend a tap and die set please that will cover all the boiler sizes so that I can run a tap through the various threaded holes. Most of the threads seem to be metric but I am not sure that they all are.
In particular can anyone tell me the thread size for the fusible plug. I've fitted the plug but am not sure it is seating in far enough.
Thanks
Martin
Can anyone recommend a tap and die set please that will cover all the boiler sizes so that I can run a tap through the various threaded holes. Most of the threads seem to be metric but I am not sure that they all are.
In particular can anyone tell me the thread size for the fusible plug. I've fitted the plug but am not sure it is seating in far enough.
Thanks
Martin
parador- Number of posts : 76
Registration date : 2008-07-02
Re: Thread sizes
Hi
All the sizes are actually given on the packing lists for all the different studs, nuts and bolts in the kits.
The fusible plug is BSP threads.
All the sizes are actually given on the packing lists for all the different studs, nuts and bolts in the kits.
The fusible plug is BSP threads.
lynnr- Number of posts : 3242
Age : 55
Location : Highland, 4inch showman
Registration date : 2010-08-06
Re: Thread sizes
Think off hand it is 3/8. I will look at my taps tomorrow.
lynnr- Number of posts : 3242
Age : 55
Location : Highland, 4inch showman
Registration date : 2010-08-06
Re: Thread sizes
If all the fittings etc to the boiler are BSP then a BSP tap and die set would be the way to go.
parador- Number of posts : 76
Registration date : 2008-07-02
Re: Thread sizes
Pretty sure all the wash outs and plug are 3/8 BSP on my Agri, the cylinder block saddle I think are metric, so I dont think its a case of just BSP on the boiler, only the bigger stuff.
LiveSteam- Number of posts : 777
Location : Hampshire
Registration date : 2013-09-08
Re: Thread sizes
Wash out plugs 1/2"bsp
Fusible 3/8"bsp
Cylinder block M8
Belly tank bracket M6
Horn plates M8
Mud hole (Dummy) M8
Not sure on sight glass
Hope this helps
Fusible 3/8"bsp
Cylinder block M8
Belly tank bracket M6
Horn plates M8
Mud hole (Dummy) M8
Not sure on sight glass
Hope this helps
Last edited by the coleman on Mon 18 Dec 2017, 8:43 pm; edited 1 time in total (Reason for editing : Spelling)
the coleman- Number of posts : 216
Age : 54
Location : worthing
Registration date : 2011-06-07
Re: Thread sizes
That helps a lot . Thanks very much.
Regards
Martin
Regards
Martin
parador- Number of posts : 76
Registration date : 2008-07-02
Similar topics
» Thread sizes
» Whistle Thread
» Couple of thread sizes
» Cylinder thread.....
» DCC Kit One (the beginning)
» Whistle Thread
» Couple of thread sizes
» Cylinder thread.....
» DCC Kit One (the beginning)
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|