Running engine on air
3 posters
Page 1 of 1
Running engine on air
Hi all hope someone can help ,engine won't run on air ,pumped up to 20 then gradually up to 80 psi loosened escentricts,crank as much as I dare but just won't turn over ,she tries but just won't go any suggestions,help would be much appreciated
Tenbore- Number of posts : 15
Location : Dorset
Registration date : 2017-09-04
Re: Running engine on air
Hi, I'm no expert, but have you checked that the piston gland isnt too tight?
Mike
Mike
Re: Running engine on air
Hi
Small check list.
1. Does it turnover by hand fairly freely?
2. How is your timing?
Check the valve event.
3. Is your valve able to move on its spindle?
4. Glands too tight?
5. Hydraulic lock?
6. A mechanical interference?
7. Regulator puck correct, and moving?
8. Do you get anything out of the whistle?
9. Do you hear anything out the chimney?
Small check list.
1. Does it turnover by hand fairly freely?
2. How is your timing?
Check the valve event.
3. Is your valve able to move on its spindle?
4. Glands too tight?
5. Hydraulic lock?
6. A mechanical interference?
7. Regulator puck correct, and moving?
8. Do you get anything out of the whistle?
9. Do you hear anything out the chimney?
Running engine on air
Thanks for the advice Lyn ,tried all what you suggested turns out to be the piston very tight in the bore, even with the glands slackened right off still tight ,don't know what can be done to resolve this one
Tenbore- Number of posts : 15
Location : Dorset
Registration date : 2017-09-04
Re: Running engine on air
Hi
Check the end gap of the rings. Otherwise the piston can be returned to have a skim off the diameter.
Check the end gap of the rings. Otherwise the piston can be returned to have a skim off the diameter.
Similar topics
» Another newbe from Scotland
» Lyka MkII - Poppapope's Build -
» 2" Burrell Kit 21
» 2" Burrell in running mode
» Up and Running!
» Lyka MkII - Poppapope's Build -
» 2" Burrell Kit 21
» 2" Burrell in running mode
» Up and Running!
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|