LH bearing
2 posters
Page 1 of 1
LH bearing
Hi Steve/Craig,
Afraid I have another problem! The left hand bearing top has been machined the wrong way round.
On mine there is an etched number 3 on each half of the bearing side. However the top half of the bearing has the oilers with the pin hols to the back of the engine i.e flip the oiler lids up from front to back whereas it should be the other way round as per the RH bearing and the isometric drawings.
I only noticed this when drilling out one of the lid pin holes as one of them was off centre.
It appears the whole bearing needs to be changed as it's machined as one item.
Any ideas ?
cheers
Afraid I have another problem! The left hand bearing top has been machined the wrong way round.
On mine there is an etched number 3 on each half of the bearing side. However the top half of the bearing has the oilers with the pin hols to the back of the engine i.e flip the oiler lids up from front to back whereas it should be the other way round as per the RH bearing and the isometric drawings.
I only noticed this when drilling out one of the lid pin holes as one of them was off centre.
It appears the whole bearing needs to be changed as it's machined as one item.
Any ideas ?
cheers
Rickster- Number of posts : 267
Location : canterbury, Kent
Registration date : 2010-02-19
LH Bearing photo
Hi Steve/Craig,
Photo of bearing attached for you to see the problem.....
Photo of bearing attached for you to see the problem.....
Rickster- Number of posts : 267
Location : canterbury, Kent
Registration date : 2010-02-19
Re: LH bearing
only just seen this, sorry (been i'll. long story but im avoiding computers at the moment)
steve just spoke to me and we are going to replace this ASAP
steve just spoke to me and we are going to replace this ASAP
craig@STW- Number of posts : 1410
Location : location Location
Registration date : 2010-05-06
Similar topics
» Crank Bearings.. your thoughts please
» RH Crank Bearing Oil Well Cover
» Loctite bearing grade
» Build so far
» RH Bearing Housing
» RH Crank Bearing Oil Well Cover
» Loctite bearing grade
» Build so far
» RH Bearing Housing
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum