kit 16 valve rod !!!

just a quick post to say we have been informed that there may be an issue with part F61613 valve rod.

it would seem that some of these have gone out with a "tight" M8 thread on the end.

it looks like the problem only affects some of the ones we have in stock so Steve suggests that you check this with the M8 nut supplied and contact him if you have a problem.

when we have an idea of the quantities involved we can make some replacements.

Craig   

Craig

I did have this problem but was able to re-cut the tread to the correct size without any problem.

Bill

Just checked mine its tight, is it cool just to re thread if so all good cheers   

yes, fine to re-thread if your happy to do so  

although the stainless steal can be quite hard. a good condition die should cope, but if anyone has any doubts just contact us.