Pump threads
3 posters
Page 1 of 1
Pump threads
Does any one know what size the threads are for the fittings in the bottom of the pump for the suction and return pipe please
Thanks
Graeme
Thanks
Graeme
GraemeJudge85- Number of posts : 7
Location : Fareham
Registration date : 2020-03-22
Re: Pump threads
Sorry , I don’t know the answer, but if you give Will a call at the factory, I am certain he will know - he is very helpful.
milford59- Number of posts : 307
Location : Milford on Sea
Registration date : 2019-05-19
Threads
Did you contact STW for the answer?
I just bought a new die and tap set for the 3/8" fittings on the Burrell, thats to the Clacks, unions, tank fittings etc and they are 9/16" x 26 BSB (British Standard Brass) I haven't tried it on the pump threads but being 3/8" pipe I suspect 9/16".
I am also adding a third method of filling the boiler, via John Rex Engineering, a 3/8" piped hand ram pump, tee and two non return valves. Bolted to the footplate via a tank filter to the mechanical pump outlet pipe. All those threads are also 9/16" x 26.
Hopefully that answers your question?
Richard.
I just bought a new die and tap set for the 3/8" fittings on the Burrell, thats to the Clacks, unions, tank fittings etc and they are 9/16" x 26 BSB (British Standard Brass) I haven't tried it on the pump threads but being 3/8" pipe I suspect 9/16".
I am also adding a third method of filling the boiler, via John Rex Engineering, a 3/8" piped hand ram pump, tee and two non return valves. Bolted to the footplate via a tank filter to the mechanical pump outlet pipe. All those threads are also 9/16" x 26.
Hopefully that answers your question?
Richard.
T140- Number of posts : 66
Location : Bristol
Registration date : 2014-05-10
Re: Pump threads
Hi thanks for the replys no I have not concated them yet a few days after asking I had my Mrs BMW timing chain go so have been rebuilding that so fun steam engine bits had to wait as its all done now and back running I can start playing again
Graeme
Graeme
GraemeJudge85- Number of posts : 7
Location : Fareham
Registration date : 2020-03-22
Re: Pump threads
Hi just thought I'd ask the question again if any one knows the thread sizes in bottom of pump for suction and return threads are looking like they need a retaping so want to make sure I am buying the correct ones
Graeme
Graeme
GraemeJudge85- Number of posts : 7
Location : Fareham
Registration date : 2020-03-22
Similar topics
» Mechanical Lubricator Threads
» Cylinder threads
» Lynn Robinson. Showman Scenic
» Tender paint
» Oiler threads
» Cylinder threads
» Lynn Robinson. Showman Scenic
» Tender paint
» Oiler threads
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|