4" Agri with Belly Tank
5 posters
Page 1 of 1
4" Agri with Belly Tank
Been a while since i've posted & finally got the belly tank fitted plus a few other bits done
Mick1020- Number of posts : 77
Location : Cork, Ireland
Registration date : 2015-08-12
tef 20, Steve Traill, LiveSteam, Mark the spark, bazzer and stevej like this post
Extra tool box fitted
Hi to all,
Made up long tool box to keep pull/push bar, tube brush & loads of space left for any other tools
Made up long tool box to keep pull/push bar, tube brush & loads of space left for any other tools
Mick1020- Number of posts : 77
Location : Cork, Ireland
Registration date : 2015-08-12
Mark the spark likes this post
lynnr- Number of posts : 3242
Age : 55
Location : Highland, 4inch showman
Registration date : 2010-08-06
Re: 4" Agri with Belly Tank
That's a good idea, helps to keep the front wheels on the ground as well.
Bazzer
Bazzer
bazzer- Number of posts : 230
Age : 64
Location : Poole
Registration date : 2015-05-01
Re: 4" Agri with Belly Tank
Hi all,
Thanks lynnr & Bazzer for your comments
20km road run was a good test for steering, all work out fine, due to the small amount of reduction of travel with belly tank
Thanks lynnr & Bazzer for your comments
20km road run was a good test for steering, all work out fine, due to the small amount of reduction of travel with belly tank
Mick1020- Number of posts : 77
Location : Cork, Ireland
Registration date : 2015-08-12
Re: 4" Agri with Belly Tank
top job!
i like the tools too
i like the tools too
andysleigh- Number of posts : 20
Age : 32
Location : guildford
Registration date : 2009-02-23
Windermere Kettle
Hi Mick1020,
Just wandering where you got some parts from.
The first one is the extra globe valve and t part coming out the top of the steam head for your blower adaptation and what thread is it.
Second of all what size pipe did you use to make the adaptation. Of the blower and the pipe to the Windermere kettle.
Thirdly where did you get the Windermere kettle from?
Many Thanks
Thunderbolt
Just wandering where you got some parts from.
The first one is the extra globe valve and t part coming out the top of the steam head for your blower adaptation and what thread is it.
Second of all what size pipe did you use to make the adaptation. Of the blower and the pipe to the Windermere kettle.
Thirdly where did you get the Windermere kettle from?
Many Thanks
Thunderbolt
Thunderbolt- Number of posts : 42
Location : N/A
Registration date : 2021-02-13
Similar topics
» Andy's 4"dcc road loco
» Cylinder block and cleading & Steering
» belly tank construction
» Belly tank
» belly tank & steering
» Cylinder block and cleading & Steering
» belly tank construction
» Belly tank
» belly tank & steering
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|