Showman Lights
4 posters
Page 1 of 1
Showman Lights
Hello All,
I have just soldiered all the lights around the canopy. Once connected to a battery charger through the connector block the lights do not light up??????
Connecting the charger to one light it lights up nicely, but on the loop I get no activity. Has anybody else experienced this problem, if so what was the resolution?
Thanks,
Brian
I have just soldiered all the lights around the canopy. Once connected to a battery charger through the connector block the lights do not light up??????
Connecting the charger to one light it lights up nicely, but on the loop I get no activity. Has anybody else experienced this problem, if so what was the resolution?
Thanks,
Brian
Brian M- Number of posts : 261
Location : Cheshire
Registration date : 2011-01-30
Re: Showman Lights
Brian,
The current drain of all the lights may be too much for the battery charger, as chargers normally only have a very low current to avoid damaging the battery when charging.
I would try a car battery to give enough power to drive all the lights.
Ian
The current drain of all the lights may be too much for the battery charger, as chargers normally only have a very low current to avoid damaging the battery when charging.
I would try a car battery to give enough power to drive all the lights.
Ian
IanL- Number of posts : 437
Age : 68
Location : Nottinghamshire
Registration date : 2011-07-25
Re: Showman Lights
Did you scrape the insulation coating off the copper wire before you soldered the light wires to it? If you didn't, the lights won't work!!
I know because, I didn't!!!
Regards,
Tony
I know because, I didn't!!!
Regards,
Tony
Tony King- Number of posts : 856
Age : 68
Location : scotland
Registration date : 2008-10-31
Re: Showman Lights
Thanks for the response chaps!
NO I did not remove the installation cover off, as it did not mention it is the instructions
It makes sense know you mention it - Thanks!
NO I did not remove the installation cover off, as it did not mention it is the instructions
It makes sense know you mention it - Thanks!
Brian M- Number of posts : 261
Location : Cheshire
Registration date : 2011-01-30
Re: Showman Lights
I believe it s in the instructions. Yes you need clean copper to solder to. Some lacquer will decompose to a sort of flux if made hot enough.
You will also need a psu that can give 12v at 27 amps to get full brightness.
You will also need a psu that can give 12v at 27 amps to get full brightness.
lynnr- Number of posts : 3242
Age : 55
Location : Highland, 4inch showman
Registration date : 2010-08-06
Similar topics
» Lynn Robinson. Showman Scenic
» Roof lights
» old new tail lights
» lights... camera...
» Two showman get an outing
» Roof lights
» old new tail lights
» lights... camera...
» Two showman get an outing
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|