Regulator and Safety Valves
2 posters
Page 1 of 1
Regulator and Safety Valves
HI STW
Since the latest kit tells us to install the safety valves. I been thinking. Would it be wiser to hold off until the regulator handle assembly arrives as currently the regulator block is not adjusted to the correct length in the cylinder.
Since the latest kit tells us to install the safety valves. I been thinking. Would it be wiser to hold off until the regulator handle assembly arrives as currently the regulator block is not adjusted to the correct length in the cylinder.
lynnr- Number of posts : 3242
Age : 55
Location : Highland, 4inch showman
Registration date : 2010-08-06
Re: Regulator and Safety Valves
Seeing we don't have any bolts to hold it down and it's unlikely to take more than 2 minutes to attach it I would say hold on. Besides depending on how you carry out the cold test you may want to get to the regulator and/or try to seal off the safeties ( or remove and replace with a blanking plate ) to hold the pressure in. As I see it there are two ways to stop the safeties from ejecting the cold test water, either a clamp of some description on the outside to keep the poppet valves shut or a blanking plate under or to completely replace the unit. I would go for the second option myself.
Similar topics
» Safety valve - blow off pressure?
» Water pump clack
» Lynn Robinson. Showman Scenic
» 4" Burrell Ramsbottom safety valves
» 4 Inch Burrell Governors and safety valves
» Water pump clack
» Lynn Robinson. Showman Scenic
» 4" Burrell Ramsbottom safety valves
» 4 Inch Burrell Governors and safety valves
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum