Cylinder gasket
3 posters
Page 1 of 1
Re: Cylinder gasket
Hi Chris,
yes, looked like on Pied Piper. Figuring that it should be open, i.e. unrestricted I fitted two studs to locate the gasket, marked and cut out the gasket just a tad to make sure the holes were not covered.
Hope this helps.
Elwood
yes, looked like on Pied Piper. Figuring that it should be open, i.e. unrestricted I fitted two studs to locate the gasket, marked and cut out the gasket just a tad to make sure the holes were not covered.
Hope this helps.
Elwood
elwood-59- Number of posts : 300
Location : Germany-NRW
Registration date : 2014-12-17
Steve Traill likes this post
Re: Cylinder gasket
Hi Elwood,
Thanks for the response, it's really helpful to know what other people have done, I'll open the gasket a tad.
Chris
Thanks for the response, it's really helpful to know what other people have done, I'll open the gasket a tad.
Chris
CJRH- Number of posts : 14
Location : Bramley
Registration date : 2021-11-03
Re: Cylinder gasket
Me also! Just trimmed it a bit!
Rgds
Greg
Rgds
Greg
Goliewogs- Number of posts : 115
Age : 73
Location : FRANCE - Normandie
Registration date : 2016-03-28
Similar topics
» Rear cylinder plate gasket
» to gasket or not to gasket
» WHISTLE GASKET
» Advice on a 4" and help
» Kit 11 - Cylinder Block & Cylinder fittings.
» to gasket or not to gasket
» WHISTLE GASKET
» Advice on a 4" and help
» Kit 11 - Cylinder Block & Cylinder fittings.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|