Differential gears
2 posters
Page 1 of 1
Differential gears
Looking for a bit of help on the drive side there is a washer with a hex bolt that you put a roll pin in to keep in place the only thing is the hex bolt comes undone or gets really tight
Thanks paul
Thanks paul
Paul1985- Number of posts : 3
Location : Nottingham
Registration date : 2019-10-31
Re: Differential gears
The pin is to stop the washer rotating and undoing the bolt, the second shaft should be flush with the shoulder on the gear that the washer sits in, it sounds like you need a spacer under the washer so you can do the bolt up tightly without everything binding up (try using a washer but make sure the pin still engages with the washer), if that doesn't work you may need to return you diff assembly to us for adjustment.
Ian- Number of posts : 113
Age : 67
Location : Daventry
Registration date : 2008-06-30
Re: Differential gears
Hello Ian
Here is a photo of the diff if I put washers under the end plate the first and second gear are a little lose and when in neural gear there is a rubbing
Here is a photo of the diff if I put washers under the end plate the first and second gear are a little lose and when in neural gear there is a rubbing
Paul1985- Number of posts : 3
Location : Nottingham
Registration date : 2019-10-31
Paul1985- Number of posts : 3
Location : Nottingham
Registration date : 2019-10-31
Re: Differential gears
Your diff assembly is too wide, measure the step between the end of the shaft and the shoulder in the diff output gear so I know how much to slim it down, send the diff back to me and I will run it in and change the width, send everything that is on ISO BU217 Sheet 3 of 5 Except the two large gears BU21705 and BU21707 and put something in there with your name on.
Regards Ian
Regards Ian
Ian- Number of posts : 113
Age : 67
Location : Daventry
Registration date : 2008-06-30
Similar topics
» Kit 17 - Differential
» Differential Problem
» Differential Noise
» 4 inch Burrell Differential
» gears again
» Differential Problem
» Differential Noise
» 4 inch Burrell Differential
» gears again
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|