Lubrication / steam oil
3 posters
Page 1 of 1
Lubrication / steam oil
Hi, is there a way to check that the channels are clear, and that steam oil is getting into the cylinder ?
I have removed the lubricator, and when i took the copper pipe off the check valve,i had a bit of a pop from the pressure that was in the pipe, between the lubricator and the check valve, is this right ?
I have removed the lubricator, and when i took the copper pipe off the check valve,i had a bit of a pop from the pressure that was in the pipe, between the lubricator and the check valve, is this right ?
Chrs777- Number of posts : 79
Location : Rochdale
Registration date : 2016-12-10
Re: Lubrication / steam oil
Hi
Check you have the non return valve the correct way round. Undo it from the block and test it on the pipework. With the valve chest open you should see oil running in to the valve chest via the steam input at the top of the block. (May take a while to get down the passage and "round the corner"
Check you have the non return valve the correct way round. Undo it from the block and test it on the pipework. With the valve chest open you should see oil running in to the valve chest via the steam input at the top of the block. (May take a while to get down the passage and "round the corner"
Re: Lubrication / steam oil
Thankyou lynn. I'm sure i got the valve on the correct way but I'll double check. Thanks for the advice on how to check in the valve chest.
Chrs777- Number of posts : 79
Location : Rochdale
Registration date : 2016-12-10
Re: Lubrication / steam oil
Hi Chris,
I had the same problem.
Take a look at my post "Please check this".
The oil way was blocked.
Barry
I had the same problem.
Take a look at my post "Please check this".
The oil way was blocked.
Barry
bazzer- Number of posts : 230
Age : 64
Location : Poole
Registration date : 2015-05-01
Re: Lubrication / steam oil
Ok thanks barry. Im not saying it is blocked yet, Just needed to know how to check. 👍
Chrs777- Number of posts : 79
Location : Rochdale
Registration date : 2016-12-10
Re: Lubrication / steam oil
Thankyou very much for the advice given... I have just taken the valve chest cover off,and the check valve, and 3mm grub screw and found that the lubrication channel was blocked by some hard swarf. Used an allen key and a small hammer to tap it clear !
Chrs777- Number of posts : 79
Location : Rochdale
Registration date : 2016-12-10
Re: Lubrication / steam oil
No problem Chris.
During my build I found lots of useful advice on the forum .
Barry
During my build I found lots of useful advice on the forum .
Barry
bazzer- Number of posts : 230
Age : 64
Location : Poole
Registration date : 2015-05-01
Similar topics
» Road Loco - 'Blackbeard'
» Steam Traction World at The Great Dorset Steam Fair
» Lubrication
» Cylinder Lubrication Issues
» Final Drive Lubrication?
» Steam Traction World at The Great Dorset Steam Fair
» Lubrication
» Cylinder Lubrication Issues
» Final Drive Lubrication?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|