Steam Traction World
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Regulator bracket

2 posters

Go down

Regulator bracket Empty Regulator bracket

Post  Jim the Shovel Sun 16 Apr 2017, 10:49 pm

For those who are not a where. The regular bracket supplied with kit 20 is for the Single Cylinder engine.
This was found to be too low and doesn't cater for the starter.

Regulator bracket 20170411

A word with Steve at STW and it appears that a revised bracket exists for the SCC.
This was a little higher and off centre to cater for the stater.

Regulator bracket 20170410

May look better if painted red so it blends in with spectacle plate. The off set bracket might not look so obvious.
Jim the Shovel
Jim the Shovel

Number of posts : 106
Location : Isle of Wight
Registration date : 2015-06-30

Back to top Go down

Regulator bracket Empty Re: Regulator bracket

Post  Simon B Mon 17 Apr 2017, 8:08 am

Hi Jim

Thanks for the update, I'll ask STW to send me the updated bracket. When I found the original didn't fit with the starter I just took it off until I got round to making a replacement.

Cheers

Simon
Simon B
Simon B

Number of posts : 161
Age : 58
Location : Egremont, Cumbria
Registration date : 2014-01-07

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum