Regulator
2 posters
Page 1 of 1
Regulator
Not sure if Tom's about but I have just tried to fit the regulator and note there is a clearance problem with the clevis that attaches to the regulator, the coupling ror also seems to hit one of the holding down bolts.
I have put a set in the rod to overcome the difference in hight between the regulator operating rod and handle but the above is still a problem any other builder had this problem??
I have put a set in the rod to overcome the difference in hight between the regulator operating rod and handle but the above is still a problem any other builder had this problem??
Vapor- Number of posts : 383
Age : 113
Location : Isle of Wight (2" Burrell & 5" Duchess ex MW)
Registration date : 2008-06-18
Regulator
Hi Iain
I have sent you an e-mail regarding this and some other problems.
Regards
Tom
I have sent you an e-mail regarding this and some other problems.
Regards
Tom
atomenter- Number of posts : 178
Location : NORTH EAST SCOTLAND
Registration date : 2008-06-26
Re: Regulator
Hi Tom
Ok great I haven't got it yet but I'll check again in a while, I have been cracking on the last few weeks I hope to light a fire shortly that should be good fun but I do have a few small annoying faults to rectify first.
Talk soon.
Ian
Ok great I haven't got it yet but I'll check again in a while, I have been cracking on the last few weeks I hope to light a fire shortly that should be good fun but I do have a few small annoying faults to rectify first.
Talk soon.
Ian
Vapor- Number of posts : 383
Age : 113
Location : Isle of Wight (2" Burrell & 5" Duchess ex MW)
Registration date : 2008-06-18
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum